Your cart is empty
You may check out all the available products and buy some in the shop
Return to shopCustom foam
Cut to fit. Built to tour.
Every pocket and finger pull is laid out for your gear, proofed with you, then CNC-cut and fitted to the case before it ships.
Foam types
Three ways to pack it.
Fast
Pluck
Pre-scored foam you pull out by hand. Good for mixed kits and gear that changes.
Exact
CNC Single
One insert machined to your gear, with finger pulls beside every piece.
Multi-layer
CNC Stack
A lift-out top layer for small parts over a deep bottom layer.
Process
From gear list to load-in.
- Send the gear listMake and model for each piece, plus brackets, cables and batteries.
- Approve the proofA top-down layout with every pocket marked. Change it until it is right.
- We cut and fitCut on our CNC table and test-fit in the shell.
- Ships show-readyReorders cut from the same saved file.
Foam proof
Send the list.
Tell us what goes in the case. We reply with a case size, a foam layout and a quote.